Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
EVAP Canister Removal and Installation (2013-18): Removal
2015 Acura RDX AWDSECTION Removal
- Floor Undercover - Remove
1. Remove the floor undercover . USA and Canada models
- EVAP Canister - Remove (USA and Canada models)
1. Disconnect the quick-connect fitting (A), the hoses (B), and the EVAP canister vent shut valve connector (C) and the FTP sensor connector (D). 2. Remove the EVAP canister (A) 3. If needed, remove the EVAP canister guard (B) and the EVAP canister brackets (C and D).
Mexico models
- EVAP Canister - Remove (Mexico models)
1. Disconnect the hoses (A), and remove the EVAP canister (B) 2. If needed, remove the EVAP canister brackets (C).
USA and Canada models
- EVAP Canister Vent Shut Valve and FTP Sensor - Removal (USA and Canada models)
1. Remove the EVAP canister vent shut valve (A) 2. Remove the FTP sensor (B).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.