Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine overheats (2014 - 15)
Diagnostic Procedure
- 1.
- 2.
Check for any engine coolant leakage (from gaskets, hoses, O-rings, etc.).
- 3.
Check for dirt, leaves, or insects on the radiator and the A/C condenser.
- 4.
Check for deteriorated coolant.
- 5.
Check for a damaged or deformed fan shrouds.
- 6.
Check the fan motors are operating properly (air should be blowing toward the engine).
- 7.
- 8.
- 9.
- 10.
- 11.
Check for plugged or deteriorated radiator hoses.
- 12.
Check for a plugged heater core or hoses.
- 13.
Check for a damaged cylinder head gasket.
Also check for
Check the radiator and A/C condenser fans are operating properly
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.