Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
2012 Acura TL Base
Electrical Component Locations
2012 Acura TL BaseSECTION Electrical Component Locations
- Accessory Power Sockets
- ACURALINK
- Audio System
- Automatic Transmission
- Battery Management System
- Blind Spot Information System
- Catalytic Converter System
- Climate Control
- Conventional Brake System
- Cruise Control
- Cylinder Head (J35Z6)
- Cylinder Head (J37A4)
- Dashboard
- Driveline/Axle
- Driver Position Memory System
- EGR System
- Electrical Compass
- Electronic Power Steering (EPS) System
- Electronic Throttle Control System
- Engine Block
- Engine Cooling System
- Engine Lubrication
- Engine Mount Control System
- Entry Lights Control System
- EVAP System
- Exterior Lights
- Fan Controls
- Fuel Fill Door Opener
- Fuel Supply System
- Gauges
- Glass
- HANDSFREELINK System
- Hood
- Horns
- Idle Control System
- Ignition Switch
- Ignition System
- Immobilizer System
- Intake Air System
- Intake Manifold And Exhaust System
- Interior Lights
- Interior Trim
- Keyless Access System
- Keyless/Power Door Locks/Security System
- M/T Clutch
- Manual Transmission
- Mirrors
- Moonroof
- Multiplex Integrated Control System
- Navigation System
- PCV System
- PGM-FI System
- Power Lumbar Support
- Power Mirrors
- Power Moonroof
- Power Seats
- Power Steering System
- Power Windows
- Rear Differential
- Rear Window Defogger
- Reminder Systems
- Safety Indicator System
- Seat Belts
- Seat Heaters
- Seats
- Starting System
- Supplemental Restraint System
- Tire Pressure Monitoring System
- Trunk Lid
- Trunk Lid Opener
- Turn Signal/Hazard Warning Lights
- Ventilated Seats
- VSA System Components
- VTEC
- Wiper System / Washer System
RENDER: 1.0x
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.