SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2012TL BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALAUXILIARY EMISSION CONTROL SYSTEMSEGR SYSTEMEGR PIPE REPLACEMENT
2012 Acura TL Base

EGR Pipe Replacement

2012 Acura TL BaseSECTION EGR Pipe Replacement
  1. Raise the vehicle on a lift.
  2. Remove the splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).
  3. Remove the mounting nuts (A).
    Fig 1: Mounting Nuts With Torque Specifications
    G08069866Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Lower the vehicle.
  5. Remove the mounting bolts (A).
    Fig 2: EGR Pipe, Gasket And Mounting Nuts With Torque Specifications
    G08069867Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the EGR pipe (B).
  7. Install the parts in the reverse order of removal with new gaskets (C).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.