Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TSX SPORT WAGON L4-2.4LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD, ENGINETIGHTENING SPECIFICATIONS
2011 Acura TSX Sport Wagon L4-2.4L
Tightening Specifications
2011 Acura TSX Sport Wagon L4-2.4LSECTION Tightening Specifications
Connecting Rod Bolt Inspection
Measure the diameter of each connecting rod bolt at point A and point B.
Calculate the difference in diameter between point A and point B.
Point A-Point B = Difference in Diameter
Install a new bolt if the difference in diameter is out of specification.
Connecting Rod Bolts
First step Finger tight
Second step 41 Nm (4.2 kg-m, 30 lb-ft)
Final step Tighten an additional 120°
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.