Ceiling Light Test/Replacement

2011 Acura TSX Sport Wagon L4-2.4LSECTION Ceiling Light Test/Replacement



Ceiling Light Test/Replacement

1. Turn the ceiling light switch OFF.

2. Carefully pry the lens (A) off with a small screwdriver.









3. Remove the screws, then remove the ceiling light (B).

4. Disconnect the 3P connector (C) from the ceiling light.

5. Check for continuity between the terminals.

- There should be continuity between terminals No. 1 and No. 2 with the switch in the MIDDLE (DOOR) position.
- There should be continuity between terminals No. 2 and No. 3 (body ground) with the switch in the ON position.
- There should be no continuity between terminals No. 1 and No. 2, and between terminals No. 2 and No. 3 (body ground) with the switch in the OFF position.

6. If the continuity is not as specified, check the bulb. If the bulb is OK, replace the ceiling light.

7. Install the light in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.