Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TSX SPORT WAGON L4-2.4LREPAIR AND DIAGNOSISLIGHTING AND HORNSTESTING AND INSPECTIONCARGO AREA LIGHT TEST/REPLACEMENT
2011 Acura TSX Sport Wagon L4-2.4L
Cargo Area Light Test/Replacement
2011 Acura TSX Sport Wagon L4-2.4LSECTION Cargo Area Light Test/Replacement
Cargo Area Light Test/Replacement
Sport Wagon
1. Open the tailgate.
2. Carefully pry out the cargo area light (A).
3. Disconnect the 2P connector (B) from the light.
4. Check for continuity between the terminals.
- There should be continuity between the No. 1 and No. 2 terminals with the switch in the ON position.
- There should be no continuity between the No. 1 and No. 2 terminals with the switch in the OFF position.
5. If the continuity is not as specified, check the bulb (C). If the bulb is OK, replace the light.
6. Install the light in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.