Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TSX SPORT WAGON L4-2.4LREPAIR AND DIAGNOSISLIGHTING AND HORNSMAP LIGHTSERVICE AND REPAIR
2011 Acura TSX Sport Wagon L4-2.4L
Map Light: Service and Repair
2011 Acura TSX Sport Wagon L4-2.4LSECTION Service and Repair
Front Individual Map Light Test/Replacement
1. Turn the map light switch OFF.
2. Carefully pry the lens (A) off with a small screwdriver.
3. Remove the screws, then remove the front individual map lights (B).
4. Disconnect the connectors (C) from the lights.
5. Check for continuity between the terminals in each switch position according to the table.
6. If the continuity is not as specified, check the bulb(s). If the bulb(s) are OK, replace the map lights.
7. Install the lights in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.