Audio-HVAC Display Unit Removal/Installation

2011 Acura TSX Sport Wagon L4-2.4LSECTION Audio-HVAC Display Unit Removal/Installation



Audio-HVAC Display Unit Removal/Installation

With Premium Audio

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the dashboard.

1. Remove the speaker cover Dashboard Speaker Cover Removal/Installation.

2. Carefully push out the audio-HVAC display unit (A).





3. Disconnect the connectors (B), and remove the audio-HVAC display unit.

4. Remove the passenger's airbag cutoff indicator Service and Repair from the audio-HVAC display unit.

5. Install the audio-HVAC display unit in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.