Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TSX SPORT WAGON L4-2.4LREPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSCRUISE CONTROL COMBINATION SWITCH TEST/REPLACEMENT
2011 Acura TSX Sport Wagon L4-2.4L
Cruise Control Combination Switch Test/Replacement
2011 Acura TSX Sport Wagon L4-2.4LSECTION Cruise Control Combination Switch Test/Replacement
Cruise Control Combination Switch Test/Replacement
SRS components are located in this area. Review the SRS component locations Locationsand precautions and procedures Service and Repair before doing repairs or service.
1. Remove the driver's airbag Driver's Airbag Replacement.
2. Remove the steering trim Overhaul.
3. Remove the select/reset/information switch (A), then remove the cruise control combination switch (B).
4. Check for continuity between the terminals in each cruise control combination switch position according to the table:
- If there is continuity, and it matches the table, but the cruise control combination switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or more positions, replace the cruise control combination switch.
5. Install the cruise control combination switch in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.