Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TSX SPORT WAGON L4-2.4LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSSTEERING ANGLE SENSORSERVICE AND REPAIR
2011 Acura TSX Sport Wagon L4-2.4L
Steering Angle Sensor: Service and Repair
2011 Acura TSX Sport Wagon L4-2.4LSECTION Service and Repair
Steering Angle Sensor Replacement
SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.
NOTE: Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.
1. Turn the ignition switch to LOCK (0).
2. With the front wheels in the straight-ahead position and the steering wheel centered, then remove the steering wheel Steering Wheel Removal.
3. Remove the steering column covers Steering Column Cover Removal/Installation and the cable reel.
4. Remove the combination switch assembly.
5. Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).
6. Install the combination switch body assembly in the reverse order of removal, and note these items:
NOTE:
- Do not remove the steering angle sensor from the combination switch body assembly.
- When installing the cable reel, set the turn signal canceling sleeve position so that the arrow points straight up.
- Tighten the combination switch assembly/cable reel mounting screws in the proper sequence.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.