Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TSX SPORT WAGON L4-2.4LREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSTESTING AND INSPECTIONPOWER MIRROR SWITCH TEST/REPLACEMENT
2011 Acura TSX Sport Wagon L4-2.4L
Power Mirror Switch Test/Replacement
2011 Acura TSX Sport Wagon L4-2.4LSECTION Power Mirror Switch Test/Replacement
Power Mirror Switch Test/Replacement
1. Remove the driver's door panel Front Door Panel Removal/Installation.
2. Remove the armrest and switch panel from the door panel Front Door Panel Removal/Installation.
3. Disconnect the 13P connector (A) from the power mirror switch (B), then remove the two screws and power mirror switch.
4. Check for continuity between the terminals in each switch position according to the table.
Power Mirror Switch
5. If the continuity is not as specified, replace the power mirror switch.
6. Install the switch in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.