Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TSX SPORT WAGON L4-2.4LREPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMCONSOLESERVICE AND REPAIRCENTER CONSOLE INNER BOX LID REMOVAL/INSTALLATION
2011 Acura TSX Sport Wagon L4-2.4L
Center Console Inner Box Lid Removal/Installation
2011 Acura TSX Sport Wagon L4-2.4LSECTION Center Console Inner Box Lid Removal/Installation
Center Console Inner Box Lid Removal/Installation
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857
NOTE:
- Take care not to scratch the center console or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove the center console panel Center Console Panel Removal/Installation.
2. Disconnect the console accessory power socket connector, the auxiliary jack assembly connector, and the USB jack connector.
3. Open the center console armrest.
4. Remove the center console box mat (A).
NOTE: It may be easier to use packing tape to remove the mat.
5. Remove the screws, then open the lid (A) by prying the hooks (B) with the appropriate trim tool.
6. Pivot the center console inner box lid (A) up on the upper hooks (B) to release the lower hook (C), then remove the lid from the console box (D).
7. Install the lid in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.