Navigation System Forced Starting of the Audio-Navigation Unit

2011 Acura TSX Sport Wagon L4-2.4LSECTION Navigation System Forced Starting of the Audio-Navigation Unit



Navigation System Forced Starting of the Audio-Navigation Unit

Special Tools Required

- SCS Service Connector 07PAZ-001010A

1. Turn the ignition switch to LOCK (0).

2. Remove the right side kick panel Service and Repair.

3. Connect the SCS service connector (A) to the navigation service check connector (B) located by the passenger's kick panel.





4. Turn the ignition switch to ON (II).

5. Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the System Links menu.

NOTE: If the display fails to display the System Links screen, refer to no picture is displayed troubleshooting Symptom Troubleshooting.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.