Communications Control Module: Service and Repair

2011 Acura TSX Sport Wagon L4-2.4LSECTION Service and Repair



HandsFreeLink Control Unit Removal/Installation

NOTE: Tell the client they need to write down all phone numbers stored in the HFL and the navigation imported phone book as there is no way to transfer the information in the original HandsFreeLink control unit to a new HandsFreeLink control unit.

1. Remove the passenger's dashboard undercover Passenger's Dashboard Undercover Removal/Installation.

2. Disconnect the 28P connector (A) from the HandsFreeLink control unit (B), and remove it.






3. Install the HandsFreeLink control unit in the reverse order of removal.

After replacing the HandsFreeLink control unit, tell the client:

- They need to pair their phones to the system.
- They need to set up their system preferences.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.