Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TL FWD V6-3.5LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRPOWER WINDOW MASTER SWITCH REPLACEMENT
2011 Acura TL FWD V6-3.5L
Power Window Master Switch Replacement
2011 Acura TL FWD V6-3.5LSECTION Power Window Master Switch Replacement
Power Window Master Switch Replacement
1. Remove the driver's door armrest.
2. Remove the two screws (A), then remove the bracket (B) from the armrest assembly (C).
3. Remove the four screws and the power window master switch (D).
4. Install the switch in the reverse order of removal.
5. After replacement, reset the power window control unit Testing and Inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.