Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Range Switch Test
2011 Acura TL FWD V6-3.5LSECTION Transmission Range Switch Test
Transmission Range Switch Test
1. Do the battery removal procedure Removal and Replacement.
2. Remove the air cleaner housing Service and Repair.
3. Remove the battery base.
4. Disconnect the transmission range switch connector.
5. Check for continuity between terminals at the transmission range switch connector. There should be continuity between the terminals in the following table for each switch position.
Transmission Range Switch Connector
6. If the test results are OK, the transmission range switch test is finished; if there is no continuity between any terminals, check that the transmission range switch installation. If the switch installation is OK, replace the switch Service and Repair.
7. Check the connectors for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
8. Install the battery base.
9. Install the air cleaner housing Service and Repair.
10. Do the battery installation procedure Removal and Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.