Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Fluid Pressure Switch B (3rd Clutch) Replacement
2011 Acura TL FWD V6-3.5LSECTION Transmission Fluid Pressure Switch B (3rd Clutch) Replacement
Transmission Fluid Pressure Switch B (3rd Clutch) Replacement
1. Raise the vehicle on a lift, or apply the parking brake, block both rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
2. Remove the front splash shield Front Splash Shield Replacement.
3. Disconnect the transmission fluid pressure switch B (3rd clutch) connector, and remove transmission fluid pressure switch B (3rd clutch) (A).
4. Install a new transmission fluid pressure switch B (3rd clutch) and a new sealing washer (B), and tighten the switch.
5. Check the connectors for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connectors securely.
6. Install the front splash shield Front Splash Shield Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.