Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TL FWD V6-3.5LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIR
2011 Acura TL FWD V6-3.5L
Ignition Switch: Service and Repair
2011 Acura TL FWD V6-3.5LSECTION Service and Repair
Ignition Switch Replacement
NOTE: SRS components are located in this area. Review the SRS component locations Locations, precautions and procedures Service and Repair before doing repairs or servicing.
1. Do the battery terminal disconnection procedure.
2. Remove the steering column covers Service and Repair.
3. Disconnect the 5P connector (A) from the ignition switch (B).
4. Remove the two screws and the ignition switch.
5. Install the parts in the reverse order of removal.
6. Do the battery terminal reconnection procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.