Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SRS Unit Replacement
2011 Acura TL FWD V6-3.5LSECTION SRS Unit Replacement
SRS Unit Replacement
Removal
1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.
2. Remove the center console Center Console Removal/Installation.
3. Pull down on the center heater joint duct (A) to remove it.
4. Remove the clips (B), then remove the left and right heater ducts (C, D).
5. Remove the two screws from the driver's side center console clip bracket (A), then remove the bracket.
6. Remove the TORX bolt (A) using a TORX T30 bit.
7. Disconnect SRS unit connectors A (39P) and B (39P) from the SRS unit (C).
NOTE: The SRS unit connectors have lever locks. Release the locks before disconnecting the connectors.
8. Remove the TORX bolts (D) using a TORX T30 bit, then remove the SRS unit from the driver's side.
Installation
1. Install the SRS unit (A) with the new TORX bolt (B) using a TORX T30 bit.
NOTE: Be sure the SRS unit is sitting squarely against it's bracket before torquing the TORX bolt.
2. Install the new TORX bolts (A) using a TORX T30 bit.
3. Connect the SRS connectors (B) to the SRS unit (C); push them into position until they click and the lever locks are fully secured.
4. Install the driver's side center console clip bracket (A) with the two screws.
5. Install the left and right heater joint ducts (A, B), then install the clips (C).
6. Install the center heater joint duct (D).
7. Make sure the heater joint ducts are installed securely.
8. Do the battery terminal reconnection procedure.
9. Make sure the SRS unit has the latest software. If it does not have the latest, update the software in the SRS unit SRS Unit Update.
10. Do the ODS unit initialization ODS Unit Initialization.
11. Check the operation of the ODS unit with the HDS ODS Unit Operation Check.
12. Confirm proper SRS operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.
13. Reinstall all removed parts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.