Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TL FWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSTESTING AND INSPECTIONTRUNK LID LATCH SWITCH TEST
2011 Acura TL FWD V6-3.5L
Trunk Lid Latch Switch Test
2011 Acura TL FWD V6-3.5LSECTION Trunk Lid Latch Switch Test
Trunk Lid Latch Switch Test
1. Open the trunk lid, and remove the trunk lid trim Interior Trim Removal/Installation - Trunk Lid.
2. Disconnect the 3P connector (A) from the trunk lid latch (B).
3. Check for continuity between terminals No. 1 and No. 2.
- There should be continuity with the trunk lid open.
- There should be no continuity with the trunk lid closed.
4. If the continuity is not as specified, replace the trunk lid latch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.