Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TL FWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSHEADLAMPSERVICE AND REPAIRHEADLIGHT REPLACEMENT
2011 Acura TL FWD V6-3.5L
Headlight Replacement
2011 Acura TL FWD V6-3.5LSECTION Headlight Replacement
Headlight Replacement
1. Turn the combination light switch OFF.
2. Remove these items:
- Front bumper Service and Repair
- Bulkhead cover Service and Repair
3. Remove the three bolts (A), and pull the headlight (B) out slightly.
4. Remove the harness clip (C) from the headlight housing, and disconnect the connectors (D) from the bulb sockets.
5. Remove the headlight with the corner upper beam (E).
NOTE: Be careful not to scratch the headlight lens and the fender.
6. Remove the bolt and the corner upper beam from the headlight.
7. Install the headlight in the reverse order of removal.
8. After replacement, adjust the headlight Adjustments.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.