Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TL FWD V6-3.5LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSERVICE AND REPAIRA/C REFRIGERANT OIL REPLACEMENT
2011 Acura TL FWD V6-3.5L
A/C Refrigerant Oil Replacement
2011 Acura TL FWD V6-3.5LSECTION A/C Refrigerant Oil Replacement
A/C Refrigerant Oil Replacement
Special Tools Required
- Oil Injector Tool Robinair ROB16256, commercially available
*
Recommended PAG oil: DENSO ND-OIL 8
P/N 38897-PR7-A01AH: 120 mL (4 fl-oz)
It is important to have the correct amount of refrigerant oil in the A/C system to ensure proper lubrication of the A/C compressor. Too little oil damages the A/C compressor; too much oil reduces the cooling capacity of the system, and can produce high vent temperatures.
- To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
- Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
- Do not spill the refrigerant oil on the vehicle; it may damage the paint; if it gets on the paint, wash it off immediately.
Add the recommended refrigerant oil in the amount listed if you replace any of the following parts:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.