Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TL FWD V6-3.5LREPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSCRUISE CONTROL COMBINATION SWITCH TEST/REPLACEMENT
2011 Acura TL FWD V6-3.5L
Cruise Control Combination Switch Test/Replacement
2011 Acura TL FWD V6-3.5LSECTION Cruise Control Combination Switch Test/Replacement
Cruise Control Combination Switch Test/Replacement
There are SRS components located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair, in the SRS before doing repairs or service.
1. Remove the steering wheel Steering Wheel Removal.
2. Remove the steering wheel rear cover Steering Wheel Removal.
3. Disconnect the cable real subharness connector (A), then remove the steering wheel trim/cruise control combination switch (B).
4. Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, but the cruise control combination switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the steering wheel trim/cruise control combination switch.
5. Install the cruise control combination switch in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.