Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TL FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMESPECIFICATIONSEXTERIOR PARTS REMOVAL/INSTALLATION
2011 Acura TL FWD V6-3.5L
Exterior Parts Removal/Installation
2011 Acura TL FWD V6-3.5LSECTION Exterior Parts Removal/Installation
Exterior Parts Removal/Installation
NOTE:
- To adjust the alignment of the hood, the doors, and the trunk lid, refer to the Acura TL Procedures.
- When adjusting the door in or out, replace the mounting bolts (A) (90102-SFA-305).
- The hood mounting bolts are special corrosion-resistant bolts. Before installing the hood, replace the mounting bolts with new ones.
- Apply spot sealer to the mating surface, then install the front fender, the hood, the doors, the fuel fill door, and the hinges.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.