Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011TL FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSSERVICE AND REPAIRPOWER MIRROR REPLACEMENT
2011 Acura TL FWD V6-3.5L
Power Mirror Replacement
2011 Acura TL FWD V6-3.5LSECTION Power Mirror Replacement
Power Mirror Replacement
NOTE: Take care not to scratch the door.
1. Remove the front door sash inner trim Front Door Sash Inner Trim Replacement.
2. Disconnect the power mirror connector (A).
3. While holding the power mirror (B), remove the nuts securing the mirror.
4. Release the catch (A) from the hole in the door, then remove the power mirror (B).
5. Install the mirror in the reverse order of removal, and note these items:
- Make sure the connector is plugged in properly.
- Make sure the power mirror operate properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.