Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011RDX 2.3 TB1REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISELECTRONIC THROTTLE CONTROL SYSTEMACCELERATOR PEDAL MODULE REMOVAL/INSTALLATION
2011 Acura RDX 2.3 TB1
Accelerator Pedal Module Removal/Installation
2011 Acura RDX 2.3 TB1SECTION Accelerator Pedal Module Removal/Installation
- Disconnect the accelerator pedal module 6P connector (A).
- Remove the accelerator pedal module (B).NOTE: The APP sensor is not available separately. Do not disassemble the accelerator pedal module.
- Install the parts in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.