Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2011RDX 2.3 TB1REPAIR AND DIAGNOSISBODY & FRAMESEATSDRIVER POSITION MEMORY SYSTEM (DPMS)
2011 Acura RDX 2.3 TB1
Driver Position Memory System (DPMS)
2011 Acura RDX 2.3 TB1SECTION Driver Position Memory System (DPMS)
- Component Location Index
- System Description
- General Troubleshooting Information
- Circuit Diagram - Power Seat
- DTC Troubleshooting
- DTC B1802: Power Seat Control Unit Failure
- DTC B1805: Power Seat Control Unit Lost Communication With Gauge Control Module (VSP/NE message); DTC B1808: Power Seat Control Unit Lost Communication With Gauge Control Module (A/T message)
- DTC B1806: Power Seat Control Unit Lost Communication With MICU
- DTC B1807: Power Seat Control Unit Lost Communication With MICU (door switch message)
- DTC B1825: Slide Pulse Error (no change in pulse for 1 second)
- DTC B1826: Front Height Pulse Error (no change in pulse for 1 second)
- DTC B1827: Rear Height Pulse Error (no change in pulse for 1 second)
- DTC B1828: Driver Seat Recline Motor Pulse Error
- DTC B1829: AT-P Signal and VSP Signal Have an Illegal Combination
- DTC B1836: Power Seat Position Sensor Circuit Short
- DTC B1837: Memory Position Calling Timeout
- DTC B1843: UART Communication Error
- DTC B1844: Power Seat Slide Switch Circuit Malfunction
- DTC B1845: Power Seat Recline Switch Circuit Malfunction
- DTC B1846: Power Seat Front Up-Down Switch Circuit Malfunction
- DTC B1847: Power Seat Rear Up-Down Switch Circuit Malfunction
- System Input Test and Function Test
- Power Seat Control Unit Input Test/Replacement
- Driving Position Memory Switch Test/Replacement
- Power Seat Adjustment Switch Test/Replacement
- Driver's Power Seat Motor Test
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.