Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER BLADESERVICE AND REPAIR
2010 Acura TL FWD V6-3.5L
Wiper Blade: Service and Repair
2010 Acura TL FWD V6-3.5LSECTION Service and Repair
Wiper Blade Replacement
1. Lift the wiper arms from the windshield.
NOTE: Lift the driver's side first.
2. Press and hold the tab (A) and slide the wiper blade (B) toward the tab to release it from the wiper arm (C).
3. Slide the rubber (A) out from the wiper blade (B).
4. Install a new rubber to the wiper blade in the reverse order of removal.
5. Install the wiper blades onto the wiper arms in the reverse order of removal.
6. Check the wiper operation, if the blades slip, turn the wiper switch OFF, and reinstall the wiper blades securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.