Shift Interlock Switch: Service and Repair

2010 Acura TL FWD V6-3.5LSECTION Service and Repair



Park Pin Switch Replacement

NOTE: The park pin switch, and the shift lock solenoid harness are not available separately. Replace the park pin switch, and the shift lock solenoid harness as a set.

1. Remove the shift lock solenoid Service and Repair.

2. Remove the harness wire ties (A), and remove the park pin switch (B).





3. Replace the park pin switch.

4. Install the park pin switch, and secure the park pin switch with a new screw (C).

5. Connect the shift lock solenoid connector to the shift lock solenoid. Then install the shift lock solenoid Service and Repair.

6. Route the harnesses as shown. Take the slack out of the harnesses, and secure the harnesses with the harness wire ties (A).





7. Install the shift lever boot base A/T Shift Lever Boot and Shift Lever Boot Base Replacement.

8. Install the shift lever assembly A/T Shift Lever Installation.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.