Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Shift Lock Stop/Shift Lock Stop Cushion Replacement
2010 Acura TL FWD V6-3.5LSECTION Shift Lock Stop/Shift Lock Stop Cushion Replacement
Shift Lock Stop/Shift Lock Stop Cushion Replacement
NOTE: Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your hands or gloves.
1. Remove the shift lock solenoid Service and Repair.
2. Remove the shift lock stop (A) and the stop cushion (B) as a set.
3. Apply silicone grease to the pin (C) on the shift lever bracket, and install new shift lock stop over the pin.
4. Install the shift lock solenoid Service and Repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.