Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Shift Lock Release and Release Spring Replacement
2010 Acura TL FWD V6-3.5LSECTION Shift Lock Release and Release Spring Replacement
Shift Lock Release and Release Spring Replacement
1. Remove the shift lever assembly A/T Shift Lever Removal.
2. Release the lock (A) of the shift lock release (B), then remove the shift lock release.
3. Remove the release spring (A) from the shift lock release (B).
4. Replace the shift lock release or the release spring.
5. Install the shift lock release spring in the shift lock release.
6. Install the shift lock release on the shift lever.
7. Make sure that the release spring end (A) is installed in the shift lock release (B), and the hooked end (C) of the release spring is on the shift lever bracket as shown.
8. Install the shift lever assembly A/T Shift Lever Installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.