Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
4th Clutch Transmission Fluid Pressure Switch Replacement
2010 Acura TL FWD V6-3.5LSECTION 4th Clutch Transmission Fluid Pressure Switch Replacement
4th Clutch Transmission Fluid Pressure Switch Replacement
1. Do the battery removal procedure Removal and Replacement.
2. Remove the air cleaner housing Service and Repair.
3. Disconnect the 4th clutch transmission fluid pressure switch connector, and remove the 4th clutch transmission fluid pressure switch (A).
4. Install a new 4th clutch transmission fluid pressure switch and a new sealing washer (B), and tighten the switch.
5. Check the connectors for rust, dirt, or oil, and clean or repair if necessary, then connect the connectors securely.
6. Install the air cleaner housing Service and Repair.
7. Do the battery installation procedure Removal and Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.