Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMSTART / STOP SWITCHTESTING AND INSPECTION
2010 Acura TL FWD V6-3.5L
Start / Stop Switch: Testing and Inspection
2010 Acura TL FWD V6-3.5LSECTION Testing and Inspection
Engine Start/Stop Switch Test/Replacement
1. Remove the driver's center trim Dashboard Center Trim Removal/Installation.
2. Disconnect the 10P connector (A) from the engine start/stop switch (B).
3. Remove the two screws, and the engine start/stop switch.
4. Check for continuity between the terminals in each switch position according to the table.
NOTE: Make sure the correct test lead (+ or -) is placed on the terminal.
5. Install the switch in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.