Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSTESTING AND INSPECTIONVANITY MIRROR LIGHT TEST/REPLACEMENT
2010 Acura TL FWD V6-3.5L
Vanity Mirror Light Test/Replacement
2010 Acura TL FWD V6-3.5LSECTION Vanity Mirror Light Test/Replacement
Vanity Mirror Light Test/Replacement
1. Remove the sunvisor Service and Repair.
2. Disconnect the 2P connector (A) from the sunvisor (B).
3. Check for continuity between terminals No. 1 and No. 2.
- With the vanity mirror cover (C) opened, there should be continuity.
- With the vanity mirror cover closed, there should be no continuity.
4. If the continuity is not as specified, check the bulbs (D). If the bulbs are OK, replace the sunvisor Service and Repair.
5. Install the parts in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.