Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSDIMMER SWITCHSERVICE AND REPAIR
2010 Acura TL FWD V6-3.5L
Dimmer Switch: Service and Repair
2010 Acura TL FWD V6-3.5LSECTION Service and Repair
Dashlights Brightness Controller Test/Replacement
1. Remove the driver's dashboard trim Driver's Dashboard Trim Removal/Installation.
2. Remove the two screws and dashlights brightness controller (A) from the driver's outer dashboard trim (B).
3. Check for continuity between the terminals in each switch position according to the table.
4. If the continuity is not as specified or LED does not turn on, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.