Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSOLAR SENSORSERVICE AND REPAIR
2010 Acura TL FWD V6-3.5L
Solar Sensor: Service and Repair
2010 Acura TL FWD V6-3.5LSECTION Service and Repair
Sunlight Sensor Replacement
1. Remove the center speaker lid Speaker Test/Replacement.
2. Push out the sunlight sensor (A) from the speaker lid, then disconnect the connector (B). Be careful not to damage the sensor or the dashboard.
3. Install the sensor in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.