Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Set Speed Does Not Cancel When the Cancel Button Is Pressed
2010 Acura TL FWD V6-3.5LSECTION Set Speed Does Not Cancel When the Cancel Button Is Pressed
Set speed does not cancel when the cancel button is pressed
Check for PGM-FI DTCs Initial Inspection and Diagnostic Overview.
Do the cruise control combination switch test Service and Repair.
Do the cruise control input test Cruise Control (PCM) Input Test.
Test the cancel switch signal input.
Also check for
Open circuit, loose or disconnected terminals:
LT GRN or ORN, GRY wire
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.