Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESCRUISE CONTROL CANNOT BE SET
2010 Acura TL FWD V6-3.5L
Cruise Control Cannot Be Set
2010 Acura TL FWD V6-3.5LSECTION Cruise Control Cannot Be Set
Cruise control cannot be set
Check the No. 10 (20 A) fuse in the under-hood fuse/relay box, and the No. 13 (15 A) fuse in the driver's under-dash fuse/relay box.
Check for PGM-FI DTCs Initial Inspection and Diagnostic Overview.
Do the cruise control combination switch test Service and Repair.
Do the cruise control input test Cruise Control (PCM) Input Test.
Also check for
Poor ground G101 (A/T model) or G301 (M/T model)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.