Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSTRACTION CONTROL SWITCHTESTING AND INSPECTION
2010 Acura TL FWD V6-3.5L
Traction Control Switch: Testing and Inspection
2010 Acura TL FWD V6-3.5LSECTION Testing and Inspection
VSA Off Switch Test
'10 model
NOTE: If the low tire pressure indicator turns ON, the VSA cannot be turned OFF. Check the tire pressure first.
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Remove the driver's dashboard undercover Driver's Dashboard Undercover Removal/Installation.
3. Push out the VSA OFF switch (A) from the back of the dashboard.
4. Disconnect the VSA OFF switch 5P connector (B).
5. On the switch side, check for continuity between the VSA OFF switch 5P connector terminals No. 1 and No. 2. There should be no continuity when the button is pressed, and continuity when the button is released.
6. Install the VSA OFF switch in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.