Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRTRUNK PASS-THROUGH LID LOCK CYLINDER REPLACEMENT
2010 Acura TL FWD V6-3.5L
Trunk Pass-Through Lid Lock Cylinder Replacement
2010 Acura TL FWD V6-3.5LSECTION Trunk Pass-Through Lid Lock Cylinder Replacement
Trunk Pass-through Lid Lock Cylinder Replacement
NOTE: Take care not to tear or damage the seat covers.
1. Remove the rear seat-back Rear Seat Removal/Installation.
2. Remove the screws, and release the hooks (A), then remove the upper cover (B).
3. Remove the screws, and release the upper hook (A), then pull out the lock cover (B) to release the lower hook (C).
4. Remove the retainer (A) with a hook-shaped tool, then remove the trunk pass-through lid lock cylinder (B) from the lid (C).
NOTE: Wear eye protection when doing this step.
5. Install the lock cylinder in the reverse order of removal, and make sure the trunk pass-through lid opens properly and locks securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.