Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT TEMPERATURE SWITCHSERVICE AND REPAIR
2010 Acura TL FWD V6-3.5L
Seat Temperature Switch: Service and Repair
2010 Acura TL FWD V6-3.5LSECTION Service and Repair
Seat Heater Switch Test/Replacement
1. Remove the shift panel Center Console Panel Removal/Installation.
2. Remove the seat heater switch from panel.
3. Check for continuity between the terminals in each switch position according to the table.
NOTE:
- Make sure the correct test lead (+ or -) is placed on the terminal.
- When check for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
- Be careful of the characteristic (Diode is one that conducts fully in one direction (forward) and not at all in the opposite direction (reverse)).
4. If the continuity is not as specified, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.