Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESKEYLESS ACCESS INDICATOR DOES NOT GO OFF OR DOES NOT COME ON (WITH KEYLESS ACCESS SYSTEM)DIAGNOSTIC PROCEDURE
2010 Acura TL FWD V6-3.5L
Diagnostic Procedure
2010 Acura TL FWD V6-3.5LSECTION Diagnostic Procedure
Keyless access indicator does not go off or does not come on
Symptom Troubleshooting Symptom Troubleshooting
Also check for
Gauge control module
Also check for
Keyless access control unit
Also check for
Power control unit
Also check for
Remote slot control unit
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.