Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2010TL FWD V6-3.5LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTCELLULAR PHONECOMMUNICATIONS CONTROL MODULESERVICE AND REPAIR
2010 Acura TL FWD V6-3.5L
Communications Control Module: Service and Repair
2010 Acura TL FWD V6-3.5LSECTION Service and Repair
HandsFreeLink Control Unit Removal/Installation
NOTE: Tell the client they need to write down all phone numbers as there is no way to transfer the information in the original HandsFreeLink control unit to a new HandsFreeLink control unit.
1. Remove the center console panel Center Console Panel Removal/Installation.
2. Disconnect the HandsFreeLink 28P connector (A).
NOTE: With keyless access: Disconnect the LF antenna 2P connector (B).
3. Remove the screws (A) and HandsFreeLink control unit (B).
4. Install the HandsFreeLink control unit in the reverse order of removal.
After replacing the HandsFreeLink control unit, tell the client:
- They need to pair their phones to the system.
- They need to set up their system preferences.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.