Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Acura RLFACTORY OEM SERVICE PROCEDURE
Under-Hood Fuse/Relay Box DTCS
UNDER-HOOD FUSE/RELAY BOX DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| B1055 | Relay control module lost communication with MICU (MICU message) |
| B1056 | Relay control module lost communication with MICU (ALARM message) |
| B1060 | Relay control module lost communication with gauge control module (VSP/NE message) |
| B1061 | Relay control module lost communication with gauge control module (A/T message) |
| B1062 | Relay control module lost communication with combination switch control unit (HLSW message) |
| B1063 | Relay control module lost communication with combination switch control unit (WIPSW message) |
| B1064 | Relay control module lost communication with driver's MPCS unit (DOORSW message) |
| B1065 | Relay control module lost communication with driver's MPCS unit (DRLOCKSW message) |
| B1066 | Relay control module lost communication with keyless access control unit (PANIC message) |
| B1075 | Headlight signal error |
| B1076 | Windshield wiper signal error |
| B1077 | Windshield wiper (As) signal error |
| B1078 | Daytime running lights malfunction (Canada) |
| B1079 | Daytime running lights malfunction (USA) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
