Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U0155: F-CAN Malfunction (PCM-Gauge Control Module)
- Turn the ignition switch ON (II).
- Clear the DTC with the HDS.
- Check for Temporary DTCs or DTCs with the HDS.
Is DTC U0155 indicated?
YES - Go to step 4.
NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the gauge control module and the PCM.
- Check for body electrical DTCs in the DTCs MENU with the HDS.
Is DTC B1168, B1169, and/or B1178 indicated?
YES - Go to step 5.
NO - Do the gauge control module input test (see GAUGE CONTROL MODULE INPUT TEST ).
- Turn the ignition switch OFF.
- Jump the SCS line with the HDS.
- Remove the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).
- Disconnect gauge control module connector A (12P).
- Disconnect PCM connector A (49P).
- Connect gauge control module connector terminal A12 to body ground with a jumper wire.
- Check for continuity between PCM connector terminal A48 and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES - Go to step 12.
NO - Repair open in the wire between the PCM (A48) and the gauge control module, then go to step 14.
- Connect gauge control module connector terminal A6 to body ground with a jumper wire.
- Check for continuity between PCM connector terminal A49 and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES - Substitute a known-good gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ), then go to step Hand recheck. If DTC U0155 is not indicated, replace the original gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ), then go to step 14.
NO - Repair open in the wire between the PCM (A49) and the gauge control module, then go to step 14.
- Reconnect all connectors.
- Turn the ignition switch ON (II).
- Reset the PCM with the HDS.
- Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
- Check for Temporary DTCs or DTCs with the HDS.
Is DTC U0155 indicated?
YES - Check for poor connections or loose terminals at the gauge control module and the PCM, then go to step 1.
NO - Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTCs troubleshooting.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.