Transmission Removal

2008 Acura TSX StandardSECTION Transmission Removal

Special Tools RequiredΒ 

  • Engine support hanger, A & Reds AAR-T-12566
  • Engine hanger/adapter VSB02C000015
  • Front subframe adapter VSB02C000016

    *These special tools are available through the Acura Tool and Equipment Program 1-888-424-6857.

NOTE: Use fender covers to avoid damaging painted surfaces.
  1. Secure the hood in its vertical position (support rod in the lower hole).
    Fig 1: Securing Hood In Its Vertical Position (Support Rod In Lower Hole)
    G05490956
  2. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped), then write down the audio presets.
  3. Disconnect the negative cable from the battery, then disconnect the positive cable.
  4. Remove the battery.
  5. Remove the air cleaner assembly (see AIR CLEANER REMOVAL/INSTALLATION ).
  6. Remove the battery base (see step 8 on ENGINE REMOVAL ).
  7. Carefully remove the slave cylinder to avoid bending the clutch line.
    NOTE: Do not operate the clutch pedal after the slave cylinder has been removed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.