Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSACURA2008TSX STANDARDREPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSMANUAL TRANSMISSION CLUTCHCLUTCH REPLACEMENTFLYWHEEL REPLACEMENT

2008 Acura TSX Standard

Flywheel Replacement

2008 Acura TSX StandardSECTION Flywheel Replacement

Install the ring gear holder (A).

Fig 1: Identifying Ring Gear Holder
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the flywheel mounting bolts in a crisscross pattern in several steps, then remove the flywheel and ring gear holder.
Install the flywheel on the crankshaft, and install the mounting bolts finger-tight.
Install the ring gear holder (A), then torque the flywheel mounting bolts (B) in a crisscross pattern in several steps.

Fig 2: Ring Gear Holder And Flywheel Mounting Bolts w/Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.