Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (AUTOMATIC TRANSMISSION)DRIVE PLATE REMOVAL AND INSTALLATION
2008 Acura TSX Standard
Drive Plate Removal and Installation
2008 Acura TSX StandardSECTION Drive Plate Removal and Installation
WARNING: This page is about a different variant/trim than selected.
- Remove the transmission assembly (see TRANSMISSION REMOVAL ).
- Remove the drive plate (A) and the washer (B) from the engine.
- Install the drive plate and the washer on the engine, and tighten the eight bolts in a crisscross pattern in two or more steps.
- Install the transmission assembly (see TRANSMISSION INSTALLATION ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.