Sunshade Replacement

2008 Acura TSX StandardSECTION Sunshade Replacement
  1. Remove the drain channel (see DRAIN CHANNEL REPLACEMENTΒ  ).
  2. Slide the sunshade (A) until you can see both sunshade slider spacers (B).
    Fig 1: Sliding Sunshade
    G05492331Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the screws, then remove both spacers.
  4. While lifting the front portion of the sunshade (A), move the sunshade forward until you can see both sunshade rear hooks (B). Do not damage the sunshade and hooks.
    Fig 2: Identifying Front Portion Of Sunshade And Sunshade Rear Hooks
    G05492332Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the screws, then remove both hooks.
  6. Remove the sunshade (A).
    Fig 3: Removing Sunshade
    G05492333Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove both front sunshade base sliders (A) and both rear sunshade base sliders (B).
    Fig 4: Removing Both Front Sunshade Base Sliders And Both Rear Sunshade Base Sliders
    G05492334Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Install the sunshade in the reverse order of removal, and check the glass position adjustment (see GLASS POSITION ADJUSTMENTΒ  ).
  9. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.